Wade Paint Co.

logowadepaint

Commercial Painting Tips from
Painting Experts in Charleston

Introduction

Painting a commercial space can seem overwhelming, but you can get the job done quickly with the right know-how and some helpful advice from painting experts.

 

As they say, knowledge is power, so arm yourself with these valuable tips from Wade Paint Co. to ensure your project succeeds!

Choosing the Right Paint

When choosing paint for a commercial project, picking the right type for the job is important. Consider the environment and the surface you’ll be painting. Opt for a high-quality latex or oil-based paint if it’s exposed to moisture or heat. Latex is easier to clean up, but oil-based products offer more durability (1).

Also, consider how much foot traffic there is in the area. If it’s low, a flat finish will do. And if it’s high, choose an eggshell or semi-gloss finish. If you need help deciding which one to go for, consult your local paint professionals, who can help and guide you.

 

When shopping around for paints, check labels for warranties and coverage rates. Some brands offer extended protection against fading and other damage caused by weathering and the ravages of time. You should also pay attention to VOC (Volatile Organic Compound) content to ensure that fumes won’t cause any health risks during or after the painting is completed.

 

selection of paint colors offered by Wade Paint Co

Finally, consider costs when selecting commercial-grade paints, as they are usually pricier than regular interior house paints. But make sure to check on quality, too. Always go with reputable brands, so you get good value out of your purchase down the line.

 

With these tips from Wade Paint Co., you can feel secure that your commercial painting project will turn out great!

Preparing the Surface

Before starting, properly preparing the surface for a successful paint job is essential. To do this, it’s important to clean the surface of any dirt or debris and then sand it until smooth. After that, you’ll want to patch any holes or cracks that may be present in the wall. And remember to use a primer before painting to ensure a longer-lasting result.

 

Here are some tips for preparing the surface for commercial painting:

  • Inspect the walls: Clean off dirt and dust with a mild cleaner and scrub brush.

  • Sand down rough spots: Use medium-grit sandpaper to ensure the surface is even and bump-free.

  • Patch up holes or cracks: Use spackle or joint compound to fill any wall gaps before painting over them.

  • Prime the wall: Primer helps paint better and ensures an even coat throughout your space.

  • Cover furniture and fixtures: Make sure everything is covered with drop cloths while you work!

 

Applying the Paint

Once you’ve prepared the surface, it’s time to start applying the paint! Start by gathering your supplies: a roller, primer, and paint.

 

It’s best to use a high-quality primer that seals out moisture and creates a smooth base for the paint. Make sure to choose an appropriate finish for the surface. Eggshell or semi-gloss are popular options.

 

Before you start painting, stir everything well, because this will help ensure an even coat. When it’s time to start rolling, apply light pressure as you move in one direction with each stroke. If you paint walls, avoid going back over wet areas, which can cause streaking.

 

Use long strokes for trim work, and keep your brush and roller manageable. Put enough paint on so that coverage is even but not too thick.

 

With any luck, your commercial project should look great after two coats of paint, allowing ample drying time between each!

Cleaning up Afterward

Once the painting is done, it’s essential to clean up. Put on safety goggles, a dust mask, and gloves for protection.

 

To get rid of any residual paint and airborne particles, vacuum the area using a HEPA filter. To remove any excess paint that may have been splattered during the project, wipe down all surfaces with a moist towel. If you use oil-based paints, use mineral or specific solvent cleaners for oil-based paints when wiping down surfaces. To remove latex-based paint residue, mix warm water with a mild detergent.

 

For wood trim, scrape off any extra dried paint using an angled putty knife or razor blade scraper, followed by light sanding if necessary.

 

Once all surfaces are wiped clean and dry, inspect your work for missed spots or areas where touch-ups may be needed.

Working with Professional Painters

If you need help with a big painting job, consider hiring professional painters like Wade Paint Co. of Charleston, South Carolina, to get the job done right. Working with a team of experienced painters has its advantages. They’ll be able to complete the job faster and more efficiently than if you were to do it alone.

 

Here are some essential tips for working with professional painters:

  • Make sure that everyone is on the same page before beginning the project. Have a clear plan in place so that all involved parties understand expectations.

  • Discuss scheduling and payment terms ahead of time, as well as any other necessary details.

  • Request samples of their past work to decide whether or not they’re the right fit for your project.

  • Have open communication between yourself and the team throughout the process. This will ensure that problems or issues can be quickly addressed before they become significant hindrances.

Conclusion

Any place may look brand new and fresh in minutes with the proper planning and supplies. However, when it comes to more complex projects, such as a big commercial painting project, the advantages of getting a pro painter like Wade Paint Co. become even clearer.

If you need painting experts to assist you in your big commercial painting project, contact Wade Paint Co. of Charleston, South Carolina.

Wade Paint Co. offers various high-quality painting services, including commercial painting. Whether it’s a large-scale or minor project, your painting requirements are considered while tailoring our commercial painting services. So go ahead and get started. Contact Wade Paint Co. today! 

Redefine your space’s appeal with Wade Paint Co.’s top-tier commercial painting service!

Reference:
(1) https://www.glidden.com/advice/when-should-you-use-latex-or-oil-based-pain

logowadepaint

Wade Paint Co.

Wade Paint Co. proudly offers interior painting and exterior painting services to the following communities: West Ashley, Daniel Island, Kiawah Island, Folly Beach, Mount Pleasant, Isle of Palm’s, Sullivan’s Island, and North Charleston.

Frequently Asked Questions

It depends on the size of the job. Professional painters typically charge hourly or flat fees, so you should get quotes from multiple painters to compare prices.

It depends on the size and complexity of the room, but typically, it can take anywhere from a few hours to several days.

For a commercial setting, the best paint type is specifically designed for your needs. Look for long-lasting paint that provides good coverage and resists fading over time.

When painting, safety should always be your top priority. Imagine yourself as a captain navigating a ship through turbulent waters. Stay focused and take the necessary precautions to ensure a safe journey. Wear protective gear like goggles and masks and provide adequate ventilation.

Yes, there are specific brushes that work best for commercial painting. Synthetic bristle brushes are most commonly used, as they hold more paint and provide a smooth finish. Flat or angled brushes are best for corners and trim work.